Search the Community

So I finished up the front brake job with no real problem. The only thing I forgot to do was spray on some anti-squeal on the backs of the brake pads, but thats only because I didn't have any at the time. Anyway, the front brakes are good, but we've been getting some vibrations in the steering wheel and the ABS is randomly kicking on. So I decide to check out the back brakes again. Seeing as I paid Midas to do my back brakes about 6 months ago, I never really looked at the job all too carefully aside from messing with the back left e-brake as I mentioned in another blog post. So, I start on the back right, I start taking it all apart and checking the work they did and thats when I realize one of the caliper pins is completely seized in place and the other one has limited movement. It took me about an hour to work that fucking pin out with my socket wrench while constantly spraying it with freeze off. wtf. I get that out, cleaned it, greased it. Ok. I go to take the rotor off and its locked in place on the e-brake. I had to whack that sunofabitch off with a rubber mallet. The rotor comes off, and so does the e-brake. After looking it over, the emergency brake was such a tight fit in the rotor, once its in place, it was causing a constant rubbing on the inside of the rotor. So I filed and sanded the damn e-brake down so it'll have a cm of breathing room. I cleaned everything up, re-assembled, tested thoroughly and its now in good shape. Roughly 5 hours on Saturday. It took me about 5 hours to get that pin out, clean everything and sand down that e-brake. So I figured the back left couldn't be as bad... Yeah. So yesterday (Sunday), I took the back left off and even tho the rotor came off easily, the brake dust on the inside of the rotor showed the e-brake was rubbing too. And of course, another seized pin in the caliper. WTF did I pay those guys for? Another 5 hours later and this side is now done. I took it for a slight test drive yesterday and the braking felt better than ever. I didn't get a chance to drive that far to see if the vibration problem is fixed yet, but I would assume the stuck caliper pins and rubbing brakes was the cause behind all that. I will never go back to that Midas again. Fucking rip off bastards.